Skip to content
Toronto Garage Storage

Single-wall garage shelving: one wall, everything off the floor

The 1-Wall Design is single-wall garage shelving: one run of wood shelving along the one wall your garage can spare, built on site in one day and fully insured. It is the simplest design I build, and the cheapest way to get tires and bins off the floor.

Close-up looking up at three finished wood garage shelves on one wall, each on 2x4 brackets with diagonal braces and a plywood deckFinished one-wall wood garage shelving with three deep shelves stacked from near the floor to high on the wall, on braced bracketsMan hanging by his hands from the top of three finished wood garage shelves on one wall, showing the braced brackets hold his weightMan lying full length on the top of three finished wood shelves on one garage wall, showing the shelf supports an adult's weight1 wall, 3 shelves — garage shelving build photo 5, by Toronto Garage Storage.
Ledger board and diagonal brace of overhead garage shelving fastened into the wall studs — construction detail from a Toronto build by Toronto Garage Storage.
Overhead garage shelving frame mid-build above a garage side door in Toronto — ledger and joists fastened to the wall before decking.

Tap a photo to open it full size.

What it costs

From $550

A standard 8 ft wall, 2 ft deep, with one shelf starts from $550, materials included. Each shelf is priced line by line (materials for the shelf plus build hours), and up to 2 extra shelves can go on the same wall. Shelves up to 16 ft wide and 2 ft deep are the standard size.

Price your wall in the calculator

Garages it suits

  • Single garages where one long side wall is free and the other side has the house door, the panel or the bikes.
  • The back wall above the hood of the car.
  • Any garage where you want to start with one wall and add more later.

This is one of the four designs under Overhead Garage Storage, where I explain how it compares with a store-bought rack.

How it's attached

Shelving is anchored into the wall studs with a diagonal brace secured by 4-inch structural screws — a minimum of 3 screws per shelf plus 2 per brace. Nothing rests on the slab and nothing hangs from the roof trusses.

Each screw is rated at 412 lb of pull-out resistance (165 lb per inch of thread × 2.5 in. in the stud), per ICC-ES ESR-5300.

Single-wall shelving questions

Which wall should the shelving go on?
Usually the long wall your car door doesn't open toward, or the back wall above the hood. When you text me a photo of your garage, that's the first thing I look at — where the shelf loads and unloads easily without the car in the way.
Can I add a second shelf on the same wall?
Yes — up to 2 extra shelves below the top one, right in the calculator, each priced by its size.
Is one wall enough?
For tires, bins and gear you rarely touch, usually yes. If you're clearing a whole garage floor, look at the 2-Wall Design — the corner is where capacity really jumps.
CallTextEmail